How to Put On Wheel Spacers?

Wheel spacers are aftermarket upgrades for many car enthusiasts. These powerful metallic round objects help in pushing the wheels out of the hub, which prevents the wheels from rubbing against each other. They are safe to use, and many drivers have also said that using the wheel spacers has helped them with better handling of the car.

However, how to put on wheel spacers is the main question here.

Therefore, Ardent Accessories has come up with this article where you are going to have a step-by-step guide on how to DIY wheel spacers. Moreover, you could also find the best wheel spacers on their website. So, let's get started and explore what Ardent Accessories has prepared for you.

Tools Required:

First of all, you must have all these tools to start installing the wheel spacers yourself. Let's have a look at the list of tools:

• Jack and Jack stand

• Lug wrench or impact gun

• Torque wrench

• Wire brush or sandpaper

• Anti-seize compound (optional)

• Wheel spacers (correct size and bolt pattern)

Once you’ve gathered all these tools, let’s move ahead to the process of putting in wheel spacers.

Installation Steps:

By following the steps told by the specialists at Ardent Accessories, you will be able to successfully install the wheel spacers.

Step #01: Preparation of Vehicle

To begin with, ensure that the surface where you are going to park the car is flat, so you make sure the car doesn’t roll off. Additionally, lightly loosen the lug nuts before lifting the car.

Step #02: Lifting the Car

Next, use a jack to lift the car properly.
Jack stands will help you hold the car securely. Never rely solely on the jack—always use jack stands for added safety.

Step #03: Remove the Wheel

Now that you have lifted the car, your next task is to remove the wheel. Therefore, fully loosen the lug nuts and place the wheel aside.

Step #04: Clean the Hub Surface

For better fixing, you must clean all the debris, dirt, and rust. For this purpose, use a wire brush or sandpaper to ensure a smooth, even surface.

Step #05: Install the Spacer

Then, align the spacer with the hub bolt and push it into place.
Use the torque wrench to tighten the bolt-on spacers using the supplied nuts.

Step #06: Reattach the Wheel

Now, place the wheel back on the spacer studs.
Using the crisscross method, hand-tighten the lug nuts evenly for balanced pressure.

Step #07: Lower the Car

Afterward, it’s time to carefully remove the jack. Slowly lower the car and simultaneously remove the jack stands.

Step #08: Torque the Lug Nuts

Next, use a torque wrench to tighten the lug nuts according to the manufacturer’s recommended specification.

Step #09: Recheck After Driving

Finally, re-monitor and retorque the lug nuts after driving 50–100 km. This ensures everything remains safely in place.

Frequently Asked Questions

1. How do I choose the right size of spacer?

By measuring the clearance between the wheel and the inner fender or suspension components.

2. What torque should I use on the lug nuts?

Always follow the vehicle manufacturer's instructions given in the owner's manual.

3. Can I stack wheel spacers?

No, stacking spacers is unsafe and could lead to failure. Always use a single, correct-size spacer.

4. Are wheel spacers safe?

Yes, they are safe if correctly positioned and matched to the right size.

Conclusion

Putting on your wheel spacers by yourself might seem like a difficult task at first. However, as long as you carefully follow the step-by-step instructions provided by Ardent Accessories, the process becomes much easier and safer.

In addition to the guide, you can also purchase high-quality wheel spacers and related accessories directly from Ardent Accessories.

After all, it is our foremost duty to prioritize our clients’ safety and satisfaction. Hopefully, this article has helped you gain the confidence to perform the installation smoothly and effectively.